Installing Module Into Matrix N3 Chassis - Enterasys Matrix 7H4202-72 Hardware Installation Manual

Installing Module into Matrix N3 Chassis

To install a DFE‐Platinum module into the Matrix N3 chassis,
the installation procedure described in "Installing Module into a Matrix E7 or Matrix N7
Chassis" on page 3‐6.
slot (1 through 3).
Figure 3-3 Installing Module into Matrix N3 Chassis
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
3-10 Installation
A DFE‐Platinum module can be installed in any available chassis
Caution: When setting the locking levers to the closed position, do not try to force the
locking levers to the point that they touch the face of the front panel. Forcing the locking
levers to this point could damage the module and chassis.
Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no
llevarlas a un punto en donde estén en contacto con el panel frontal. Si lo hace, podría
dañar el módulo o el chasis.
Æ
Ä
Ã
Â
À
5 Module upper locking lever (shown in closed position)
6 Module lower locking lever (shown in closed position)
7 FTM2 backplane connectors
refer to Figure 3‐3 and use
Á
Å