Before installing the module, review the requirements and specifications referred to in
this chapter concerning the following:
For information about...
10BASE-T Network
100BASE-TX Network
The network installation must meet the requirements to ensure satisfactory performance
of this equipment. Failure to do so will produce poor network performance.
10BASE-T Network
When connecting a 10BASE‐T segment to any of the module fixed front panel ports of the
7H4202‐72, ensure that the network meets the Ethernet network requirements of the
IEEE 802.3‐2002 standard for 10BASE‐T. Refer to the Cabling Guide for details.
Note: The Enterasys Matrix™ DFE-Platinum Series Configuration Guide and the Cabling
Guide referred to in the following sections can be found on the Enterasys Networks World
Wide Web site:
http://www.enterasys.com/
Refer to
"Related Documents"
Note: If a port is to operate at 100 Mbps, Category 5 cabling must be used. Category 3
cabling does not meet 100 Mbps specifications. For 10 Mbps operation only, Category 3 or
Category 5 cabling can be used. Refer to
information about 100BASE-TX networks and cabling.
Network Requirements
on page xiv.
"100BASE-TX Network"
DFE-Platinum Series Hardware Installation Guide 2-1
2
Refer to page...
2-1
2-2
on page 2-2 for