Optional Installations And Mode Switch Bank Settings; Required Tools; Removing The Chassis Cover; B.1 Required Tools - Enterasys 2200 Installation & User Manual

ELECTRICAL HAZARD: ONLY QUALIFIED SERVICE PERSONNEL SHOULD
ATTEMPT THE FOLLOWING PROCEDURES.
NUR QUALIFIEZIERTE SERVICE PERSONNAL DIE FOLGENDE PROCEDURE
FOLGEN SOLLTEN.
SOLAMENTE PERSONAL CALIFICADO DEBE INTENTAR ESTE PROCEDIMIENTO.
The top cover must be removed to gain access to the mode bank switches, to install optional
FLASH or DRAM Single In-line Memory Modules (SIMMs), or to install an optional High Speed
Interface Module (HSIM) or Very High Speed Interface Module (VHSIM).
This appendix covers the following items:
•

Required tools

(Section
•

Removing the chassis cover

•
Locations, functions, and settings for the mode switches
•
Installing optional SIMM upgrades
•
Location of Optional HSIMs
B.1 REQUIRED TOOLS
Use the following tools to perform the procedures provided in this appendix:
•
Antistatic wrist strap
•
Phillips screwdriver
Optional Installations and
Mode Switch Bank Settings
B.1)
(Section B.2)
(Section
(Section B.5)

Optional Installations and Mode Switch Bank Settings

(Section
B.4)
B.3)
B
B-1