Dte Cable - Cabletron Systems IA1100 Getting Started Manual

DTE Cable

Use the RJ-45 10/100Base-TX DTE port (marked "10/100 MGMT" on the IA 1100/1200's
chassis) for Telnet connection from a host on the network. The port is configured for
Media Data Interface (MDI). The DTE cable should have the following pin assignments:
Table 12. RJ-45 Connector Pin Assignments
Signal (IA 1100/1200 port)
TXD (transmit data)
TXD (transmit data)
RXD (receive data)
RXD (receive data)
* The right hand column pin assignments are for the RJ-45 connector on the IA 1100/1200. Thus, pin 1
(TXD or "transmit data") must emerge on the management console's end of the connection as RXD
("receive data") and so on.
Internet Appliance 1100/1200 Getting Started Guide
Unused
Unused
Unused
Unused
Appendix C: Hardware Specifications
Pin Signal (management console port)
1 RXD (receive data)
2 RXD (receive data)
3 TXD (transmit data)
4
5
6 TXD (transmit data)
7
8
*
Unused
Unused
Unused
Unused
63