Basic Line Editing Commands - Cabletron Systems IA1100 Getting Started Manual

Note: When you exit Configure mode, the CLI will ask you whether you want to
activate the configuration commands you have issued. If you enter yes or y, the
configuration commands you issued are placed into effect and the IA 1100/1200's
configuration is changed accordingly. However, the changes are not written to the
Startup configuration file in the IA 1100/1200's boot flash and therefore are not
reinstated after a reboot. See "Activating Configuration Changes and Saving the
Configuration File" on page 32 for information about saving configuration
changes.

Basic Line Editing Commands

The CLI supports EMACs-like line editing commands. The following table lists some
commonly used commands. For a complete set of commands, see the Internet Appliance
User Reference Manual.
Table 3. Some Commonly-Used CLI Commands
Key sequence
Ctrl+A
Ctrl+B
Ctrl+D
Ctrl+E
Ctrl+F
Ctrl+N
Ctrl+P
Ctrl+U
Ctrl+X
Ctrl+Z
Internet Appliance 1100/1200 Getting Started Guide
Move cursor to beginning of line
Move cursor back one character
Delete character
Move cursor to end of line
Move cursor forward one character
Scroll to next command in command history (use the cli show
history command to display the history)
Scroll to previous command in command history
Erase entire line
Erase from cursor to end of line
Exit current access mode to previous access mode
Chapter 3: Basic System Setup
Command
21