Table of Contents
Advertisement
Chapter 3: Basic System Setup
The new configuration changes are added to the Startup configuration file stored in the IA
1100/1200's boot flash.
Viewing the Current Configuration
If you want to view the current configuration:
1.
Ensure that you are in Enable mode by entering the enable command in the CLI.
2.
Enter the following command to display the status of each command line:
system show active-config
The CLI displays the active configuration file with the following possible annotations:
–
Commands without errors are displayed without any annotation.
–
Commands with errors are annotated with an "E".
–
If a particular command has been applied such that it can be expanded on
additional interfaces/modules, then it is annotated with a "P". For example, if you
enabled STP on all ports in the current system, however, the IA contains only one
module, then that particular command could be expanded at a later date when
more modules have been added to the IA.
A command like stp enable et.*.* would be displayed as follows:
P: stp enable et.*.*
indicating that it is only partially applied. If you add more modules to the IA at a
later date and then update the configuration file to encompass all of the available
modules in the IA, then the "P:" portion of the above command line would
disappear when displaying this configuration file.
If a potentially partial command, which was originally configured to encompass
all of the available modules on the IA, becomes only partially activated (after a
hotswap or some such chassis reconfiguration), then the status of that command
line will automatically change to indicate a partial completion status, complete
with "P:".
Note:
34
Commands with no annotation or annotated with a "P:" are not in error.
Internet Appliance 1100/1200 Getting Started Guide
Advertisement
Table of Contents
