Table of Contents
Advertisement
Chapter 5: Software Upgrade
Here is an example:
ia# system image add 10.50.11.12 ia1000
Downloading image 'ia1000' from host '10.50.11.12'
to local image ia1000 (takes about 3 minutes)
kernel: 100%
Image checksum validated.
Image added.
4.
Enter the system image list command to verify that the new image exists on the
internal flash chip, as shown in the following example:
ia# system image list
Images currently available:
ia1000
5.
Use the following command to select the image file the IA 1100/1200 will use the next
time you reboot the switch.
system image choose
Here is an example:
ia# system image choose ia1000
Making image ia1000 the active image for next reboot
6.
Enter the system image list command to verify the change.
Note:
Loading Boot PROM Software
The IA boots using the boot PROM software installed in the IA 1100/1200's internal
memory. To upgrade the boot PROM software and boot using the upgraded image, use
the following procedure.
1.
Display the current boot settings by entering the system show version command, as
shown in the following example:
ia# system show version
Software Information
Software Version
Copyright
Image Information
Image Boot Location: tftp://10.50.89.88/ia1000
Boot Prom Version
46
<file-name>
You do not need to activate this change.
: 3.0.1.0
: Copyright (c) 2000 Cabletron Systems, Inc.
: Version 3.0.1.0, built on Thu Jan 27 01:16:15 2000
: prom-1.1.0.5
Internet Appliance 1100/1200 Getting Started Guide
Advertisement
Table of Contents
