Table of Contents
Advertisement
Chapter 3: Basic System Setup
6.
Enter the show command to show the commands you just entered. Because you have
not activated these configuration changes yet, they are listed in the scratchpad section
of the output. Here is an example:
ia(config)# show
Running system configuration:
!
! Last modified from Console on Mon Jan 19 12:37:21 1998
!
1 : interface add ip en0 address-netmask 10.50.11.22/16
!
2 : system set dns server 10.50.11.12
3 : system set dns domain mktg.cabletron.com
4 : system set name "ia"
5 : system set location "Sunnyvale, CA
6 : system set contact "John Smith"
7 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a
8 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a
!
9 : snmp set community public privilege read
10 : snmp set target 10.50.11.12 community public
******** Non-committed changes in Scratchpad ********
1*: system set syslog server 10.50.11.12
2*: system set syslog level info
3*: system set syslog facility local0
Note:
7.
To activate the SYSLOG commands, enter the save active command.
Activating Configuration Changes and Saving the
Configuration File
The IA 1100/1200 uses three special configuration files:
•
Active – The commands from the Startup configuration file and any configuration
commands that you have made active from the scratchpad (see below).
: The active configuration remains in effect only during the current power cycle. If
Caution
you power down or reboot the IA 1100/1200 without saving the active configuration
changes to the Startup configuration file, the changes are lost.
•
Startup – The configuration file that the IA 1100/1200 uses to configure itself when the
system is powered on.
•
Scratchpad – The configuration commands you have entered during a management
session. These commands do not become active until you explicitly activate them.
Because some commands depend on other commands for successful execution, the IA
1100/1200 scratchpad simplifies system configuration by allowing you to enter
32
The other configuration changes made during this CLI session are also listed.
Active changes are listed in the "Running system configuration section" and
unactivated changes are listed in the "Non-committed changes in
Scratchpad" section.
Internet Appliance 1100/1200 Getting Started Guide
Advertisement
Table of Contents
