This chapter describes the basic steps for configuring the IA 1100/1200 for the following
features:
•
Load balancing
•
Web caching
•
IP policy-based routing
Configuration of the IA 1100/1200 is performed by entering CLI commands in Configure
mode from either the system console or a Telnet session. Refer to Chapter 3, "Basic System
Setup" on page 19 for information about starting and using the CLI.
This chapter describes the minimum steps necessary to configure the above features on
the IA 1100/1200. Many more options are configurable for each of these features. Refer to
the Internet Appliance User Reference Manual and the Internet Appliance Command Line
Interface Reference Manual for the complete set of configuration commands.
Internet Appliance 1100/1200 Getting Started Guide
Chapter 4
Configuration
35