Advertisement
Operating
Manual
1) Remove the three cap screws (4mm hex) and the one flat head screw (3mm hex) as
shown.
2) Remove the side cover after screws are removed. The side cover is a close fit and may
require a screwdriver to pry off near the tension arm.
3) Examine the mechanical linkages for over-all condition such as dirt, metal filings, liquid
contamination and lubrication.
1)
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Maintenance: Tool Body and Linkages
Pry Here
www.BAND-IT-IDEX.com
Cutoff Link
Front Cutoff
Lever
Head
Head Pin
Page 32 of 36
IT1000-C / IT2000-C
1/4" IT Tool
Cutoff Toggle
Tension Arm
Gripper
Front
Release Arm
Gripper
Document # P49050 Rev. C
BAND-IT-IDEX, Inc. 2015
All rights reserved
© Copyright
Advertisement
