Advertisement
Operating
Manual
The IT1000-C forms a locking dimple into
the Tie-Lok tie with the punch and cuts the
remaining tail. When installing a Tie-Lok tie,
a visual check is recommended to verify the
presence of a locking dimple after the tie
has been applied.
The IT2000-C forms a locking lip on the
preformed JR clamp and cuts the remaining
tail. When installing a JR clamp, a visual
check is recommended to verify the
presence of the locking lip after the clamp
has been applied.
By controlling and monitoring the items that are needed to form a good lock, an operator
can help ensure that the clamp will be applied correctly without having to inspect every
assembly. The key issues are:
• Adequate air pressure and volume (Pg.9)
• Appropriately setting the tension and cutoff air pressure for the application (Pg.12)
• Angle of approach (Pg.14)
• Operator Handling Ergonomics (Pg.19)
• Mounting the tool on a weight balancer or custom fixture (Pg.21)
• Following the recommended Preventative Maintenance schedule (Pg.27)
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Tie / Clamp Inspection
Locking Dimple
Locking Lip
www.BAND-IT-IDEX.com
Page 15 of 36
IT1000-C / IT2000-C
1/4" IT Tool
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
