Advertisement
Operating
Manual
Symptom
Difficulty inserting clamp
tail into tool.
Tool does not cycle
when the trigger is
pressed.
Tool tightens clamp, but
cutoff does not activate.
Tool attempts to cutoff
and lock the clamp
before it is tight.
Tool fails to cut or lock
clamp.
(Press reset button to
release tool from clamp if
stalled)
Clamp is loose after
cutoff.
Contact BAND-IT-IDEX Customer Service at 1-800-525-0758 or 303-320-4555 for
repair on any issues not addressed above.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Trouble Shooting Guide: Tool Symptoms
Items to check
Is there a clamp tail already in the
tool?
Do the gauges on the control module
show pressure?
Do the gauges on the control module
show pressure?
After the tool stalls, does nothing
further happen? (no sound of the
cylinder moving)
Does the cylinder sound as though it
moves, but the knife does not extend?
Is the cutoff timing too short?
Is the tool struggling to pull up the
clamp?
Check tension and cutoff pressures.
Check knife and blade for excessive
wear or chips on the cutting edges.
For TLT/ IT1000, Check dimple punch
& tool orientation allowing buckle to
enter dimple clip.
For JR/ IT2000,check that proper
blade is installed .
www.BAND-IT-IDEX.com
Remove previous clamp tail.
Check incoming supply pressure.
Turn the air regulator valve ON.
Check incoming supply pressure.
Turn the air regulator valve ON.
Check for pinched air lines under the
handle cover.
Check for pinched air lines.
Check cutoff timing.
Remove the side body and verify all links
are present and connected.
Verify there is a knife installed.
Adjust cutoff timing.
Increase tension pressure.
Lubricate the tool.
Adjust pressure regulators if not set at
specification. Verify that the hose from the
tension regulator enters the bottom port of
the tool.
Replace as necessary.
Replace damaged or incorrect parts;
assemble with buckle entering dimple clip.
Do not allow fixture interference with tool
motion.
Page 26 of 36
IT1000-C / IT2000-C
1/4" IT Tool
Suggested fix
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
