Advertisement
Operating
Manual
Maintenance: Cutter Blade Inspection & Replacement
Removal & Installation:
1)
Remove the four M3x8 screws with a 2.5mm
hex key. This can occur with the tool fully
assembled.
2)
Pull the cutter blade off of the two alignment pins
in the tool head.
3)
Inspect cutter blade for chips and excessive
wear on cutting edge. Replace if blade is
causing unacceptable clamp cut-off. Clean any
shavings or debris that have built up on cutter
blade.
4)
Remove all accumulated shavings and debris
from inside the front gripper where the ball
bearing is inserted. The part can be pulled back
and out of the tool head slot.
5)
Lubricate ball bearing after cleaning.
6)
To re-install cutter blade, use alignment pins and
install the four M3x8 screws with blue Loctite.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 31 of 36
IT1000-C / IT2000-C
Front Gripper
1/4" IT Tool
Cutter Blade
Ball
Bearing
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
