Advertisement
Operating
Manual
Important: Before disassembling tool, be sure to shut-off air supply on the
Control Module.
Note: This tool uses metric fasteners.
1) Remove the two e-style
retaining rings and two clevis
pins. Remove the
maintenance cover.
2) Remove the tension block
assembly by lifting it out of
tension arm slot. Tension block
may come out with
maintenance cover.
3) Fully clean and lubricate inside
of maintenance cover as
shown.
Maintenance Cover
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Maintenance: Maintenance Cover
Lightly lubricate all
points indicated
with red arrows.
Tension
Block
Assembly
***Continued on next page***
www.BAND-IT-IDEX.com
Page 29 of 36
IT1000-C / IT2000-C
1/4" IT Tool
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
