Advertisement
Operating
Manual
•
A tool with trigger option 0 is manually operated via the thumb button. A tool with trigger
option 1 is configured to allow remote operation via palm button or other device permitting
the tool to be incorporated into the customer's fixture or assembly process.
•
The modification consists of deactivating the thumb lever actuation switch and installing two
6-ft X 1/8" O.D. hoses with quick disconnects. These lines can be connected to any valve
used as a remote actuation device. Examples include palm buttons, foot control pedals,
and others.
•
Various actuation devices can be incorporated based upon end user requirements. Basic
schematic for 2-way & 3-way valves included below. The valve should be set up in the
normally closed mode and upon opening the circuit a supply of air is provided.
•
The customer is responsible for incorporating this tool into their process. BAND-IT-IDEX is
available to provide advice and recommendations.
Remote trigger: 2-way valve
Hose from tool
(male quick disconnect)
Actuate to
stop tool
Supply Hose from
tool (female quick disconnect)
Remote trigger: 3-way valve
Hose from
tool (male)
Actuate to
stop tool
Supply Hose from
tool (female)
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Remote Actuation Configuration
Actuate to
start tool
Actuate to
start tool
www.BAND-IT-IDEX.com
Page 23 of 36
Multiple Triggers
Hose from tool
(male)
If more than one trigger is used,
connect in series. All need to be
actuated to run the tool.
Supply Hose from
tool (female)
IT1000-C / IT2000-C
1/4" IT Tool
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Advertisement
