Auto Run, Self-Program Run; Edit Self-Program; Check The Lighting Information; Lighting Setting Parameter Reset - Blizzard Lighting TOURnado IP BAY Manual

2) Press the【UP/DOWN】button to select【1-255】numerical value.
3) Press the【ENTER】button to escape and save.
6.11

AUTO RUN, SELF-PROGRAM RUN

1)Press the【ENTER】button in【AUTO】menu, then enter to the auto run,self-program run.
2)Press the【UP/DOWN】button to select【AT01】...【AT33】，【SPEED】...【CHASE03】
3)Press the【ENTER】button to start running.
6.12

EDIT SELF-PROGRAM

1) Press the【ENTER】button in【PROG】menu, then enter to the edit self-program.
2) Press the【UP/DOWN】button to select【CHASE01】...【CHASE03】
3) Press the【ENTER】button for confirmation and enter to the next menu.
4) Press the【UP/DOWN】button to select【SCENE01】...【SCENE20】
5) Press the【ENTER】button for confirmation and enter to the next menu.
6) Then press the【UP/DOWN】button to select【RED1】...【TIME】，【WAIT】，【USE】
7) Press the【UP/DOWN】button to set up the parameter which are needed.
8) Press the【ENTER】button t o escape and save.
Illustrations：When 【USE】 is set to be 【NO】 ，or the parameter of 【 TIME】 is 0, it will not run this scene.When
【WAIT】is set to be FADE time, the running process isas the following chart showing.
6.13

CHECK THE LIGHTING INFORMATION

1) Press the【ENTER】button in【INFO】menu, then enter to the checking the lighting information.
2) 【SOFT】button is for software version information.
3) 【TEMP1】,【TEMP2】Current temperature of lamp board.
4) 【POW】button is for the current information of power reduction.
6.14

LIGHTING SETTING PARAMETER RESET

1) Press the【ENTER】button in【ST L】menu, then enter to the lighting setting parameter reset.
14