Static Setting; Dmx Signal Selection Setting; Wireless Set; Auto Lock Key Setting - Blizzard Lighting TOURnado IP BAY Manual

3) Press the【ENTER】button to escape and save.

6.2 STATIC SETTING

1) Press the【ENTER】button in 【STAT】menu, then enter to the static setting.
2) Press the【UP/DOWN】 button to select 【RED1】，【GREEN1】，【BLUE1】...【WHITE2】and【SHUT
】.
3) Press the【UP/DOWN】button to set up the【0-255】numerical value.
4) Press the【ENTER】button to escape and save.

6.3 DMX signal selection setting

1) Press the【ENTER】button in【SIGN】menu, then enter to the DMX signal selection setting.
2) Press the【UP/DOWN】button to select【2.4G】,【CABLE】
3) Press the【ENTER】button to escape and save.

6.4 Wireless set

1) Press the【ENTER】button in【WIRE】menu, then enter to the wireless set.
2)【RESET】the Analog process of press the button on again after wireless module off
3)【KEY】similar as the build-out kep

6.5 AUTO LOCK KEY SETTING

1) Press the【ENTER】button in【LOCK】menu, then enter auto lock key setting.
2) Press the【UP/DOWN】button to select【YES】,【NO】
3) Press the【ENTER】button to escape and save.
Instructions:
When set to [YES], it will lock automatically after two minutes to prevent accidental triggering flood
flushing, and then press any key for 10 seconds to unlock.

6.6 COLOR CAST CALIBRATION SETTING

1) Press the【ENTER】button in 【CAL】menu, then enter to the color cast calibration setting.
2) Press the【UP/DOWN】button to select 【RED】，【GREEN】，【BLUE】，【 UV 】and【WHITE】.
3) Press the【UP/DOWN】button to set up the【0-255】numerical value.
4) On the【USE】interface, pressing【YES】button means valid,【NO】means invalid.
5) Press the【ENTER】button to escape and save.
12