Taylor-Dunn B0-248-TT Operation, T Roubleshooting And Replacement Parts Manual page 77

Woodruf Key
Adjusting screw
Nut
3rd Member
Washer
Mounting Plate
Chain Case Housing
8. Install the chain case housing onto the pinion shaft
and tighten the pinion nut to 75 ft-lbs.
9. Install and tighten the three nuts and washers to
the threaded studs and the housing bolts that are
not used for the brake mounting bracket or
alignment brackets.
Maintenance, Service, and Repair
Motor
Nut
Bolt
O-Ring
Backing Plate
24
Washer
Nut
Pinion Seal
Brake Assembly
Motor Sprocket
Nut
Spacer
Drive Sprocket
Bolt
Bolt
Drain Plug
10. Remove the centering tool and install a new pinion
seal. Lightly lubricate the pinion seal lip.
11. Install the brake assembly and the brake band
alignment bracket(s). Do not tighten the bolts at
this time.
12. Install the brake drum. Torque to 175 ft-lbs.
13. Tighten the brake adjusting bolt to 25 ft-lbs.
14. Tighten the brake assembly mounting bolts.
15. Adjust the brake. Refer to section
Service: Adjust the Brakes
regarding adjusting the brakes.
16. Adjust the drive chain. Refer to section
the Drive Chain
for information regarding
adjusting the drive chain.
Drive Chain
Pinion Nut
Brake
for information
Adjust
F2/F3 Transmission
Page 7