3．3 Setting Menu 2: Communication Settings; Communication - Mitsubishi Electric ME96SSH-MB User Manual

3. Setting
3.3 Setting Menu 2: Communication Settings (Setting the MODBUS

communication)

In the operation mode, press
becomes available.
Setting Menu
DISPLAY SET
①Communication
method selection
DISPLAY SET
®
②MODBUS
RTU
address
DISPLAY SET
®
③MODBUS
RTU
baud rates
DISPLAY SET
®
④MODBUS
RTU
parity
DISPLAY SET
®
⑤MODBUS
RTU
stop bit
DISPLAY SET
+ simultaneously for 2 seconds or more, and the following operation
RESET
SET
Set the setting menu number to "2".
(as shown in the right figure)
Select either of "CC-Link communication" or "MODBUS
When the ME-0040C-SS96 optional plug-in module is not installed,
this display will be skipped.
：CC-Link
communication
CC
®
Mb．rtu ：MODBUS
RTU
When "CC-Link communication" is selected, go to
 CC-Link station number.
®
Set the MODBUS RTU address number.
When the CC-Link communication is selected in
Communication method selection, this display will be skipped.
Selectable addresses: 1 to 255
®
Set the MODBUS RTU baud rate.
When the CC-Link communication is selected in
Communication method selection, this display will be skipped.
2400bps
4800bps
9600bps
19.2kbps
38.4kbps
®
Set the MODBUS RTU parity.
When the CC-Link communication is selected in
Communication method selection, this display will be skipped.
non
odd
even（EVEn）
®
Set the MODBUS RTU stop bit.
When the CC-Link communication is selected in
Communication method selection, this display will be skipped.
Stop bit 1
®
RTU communication and CC-Link
communication
Stop bit 2
- 19 -
®
RTU communication."