4．2 Test Menu 2: Alarm Output/Digital Output Operation Test - Mitsubishi Electric ME96SSH-MB User Manual

4. Using Test Mode
4.2 Test Menu 2: Alarm Output/Digital Output Operation Test
The following operations are available in the test mode.
・When the ME-4210-SS96 or ME-0052-SS96 optional plug-in module is not installed, this test menu will be skipped.
・When ⑨Pulse/Alarm output 1(Setting Menu 5) and ⑫Pulse/Alarm output 2(Setting Menu 5) is not set to "AL",
this test menu will be skipped.(ME-4210-SS96)
Test menu
DISPLAY SET
①
Alarm output/Digital
output CH1 operation test
DISPLAY SET
②
Alarm output/Digital
output CH2 operation test
SET
Test menu
Set the test menu number to "2".
Execute the alarm output/digital output CH1 operation test.
When is pressed for 2 seconds, digital output is switched
RESET
back.
RESET Press for 2 seconds
oFF on
(Open) (Close)
Note2: When ⑨Pulse/Alarm output 1(Setting Menu 5) is not set to "AL",
this display will be skipped.(ME-4210-SS96)
Execute the alarm output/digital output CH2 operation test.
The test method is the same as
①Alarm output/Digital output
Note1: When ⑫Pulse/Alarm output 2(Setting Menu 5) is not set to "AL",
this display will be skipped.(ME-4210-SS96)
<To continue other test mode>
⇒
Select other test menu number and then press
<To close test mode>
⇒
Select "End" as the test menu number and then press
You will return to the operation mode.
Note1: To return to the test menu,
turn digital output OFF (open).
CH1 operation test .
SET
- 44 -
The current output
status is displayed.
.
.
SET