idp Smart Series User Manual page 65

4.2.2 Select printer and control
When you execute CardPrinterTest, it will search connected printers by USB and Network
automatically and SMART-50 printer connected to USB has higher priority. Other printers could be
selected by pull-down menu. You can test all function with connected printer.
. Control is consisted by SBS(Step by Step), Move, Rotate, Etc. section and you can control printer by
each step.

SBS
SBS is to operate SMART-50 printer in SBS(Step-By-Step) mode which you can control the
printer using commands. In SBS mode, after printing data transmission, printing a card will be
run only by clicking "DoPrint". It is the main difference between NORMAL mode and SBS mode.
When you click "Start", SMART-50 is operated in SBS mode, and existing spooled data will be
eliminated. To exit SBS mode, click "Stop".

Card
Card is to bring a card into printer and eject a card. "In" is to move a card from input hopper to
printer and "Out" is to move a card from printer to output hopper. In case the flipper is installed,
"Back" ejects a card to the back side.

Move
Move is to move a card to specific position in the inside of printer. "Print" is to move a card to
the printing position, and "Mag." is to the magnetic encoding position, and "IC" is to the contact
smartcard encoding position, and "RF" is to the contactless smartcard encoding position. "To
Rotator" is to move a card from printer to flipper and "From Rotator" is to move a card from
flipper to printer. "from In" is to move a card from the card in sensor to where you define
position, and "from Out" is to move a card from the card out sensor to where you define position.

Rotate
Rotator is to flip over a card in the printer installed flipper. "Auto" is to move a card from printer
to flipper and flip over a card and move a card to the printing position automatically. "Batch" is
to repeat "Auto" as many times as the number of set. "To Bottom" is to turn to the backside of
card and "To Top" is to turn to the front side of card.

Etc
"Cleaning Roller" is to clean the roller by cleaning card automatically. "Use Log" is to display log
in message space.
4.2.3 Print
Print can be done through the CSD file which is designed by Smart Design program. Following the
steps in this section.
1. Click "..." button and select the CSD file.
2. Click "Open" button to prepare CSD file to print.
Click "Print" Button to move print data to spool. In the NORMAL mode, Click "Print" button to
3.
print a card, but in the SBS mode, "Print" button to transmit a printing data from PC to printer
and wait for printing. Therefore, you must click "DoPrint" to print in SBS mode. This function is
for detail control of printer.
4. Click "Close" button to close CSD file.
4.2.4. Batch
Batch is to repeat encoding/decoding test continuously. In the Repeat, you input the number of repeat
and click "Batch Start", then the test is run as many times as the number of set. When you check
"Include Card In/Out", each time the printer bring a card from input hopper and perform an encoding
65