Pic.113 Color Density; Pic.114 Resin Black Density; Pic.115 Overlay Density - idp Smart Series User Manual

Black Density: To set resin black density. In the picture, barcode is printed to express
density.
When density is too strong, barcode is printed too thick. When density is too weak, barcode
is too thin. Please adjust resin black density to express clear barcode. Please refer
following pictures.
Overlay Density: To set overlay density. Please set it when overlay is printed on surface
regularly. If it is too strong, it is hazy and marks are appeared. If it is too weak, overlay panel
is not printed edge areas. You can check it with printed card under the light.
⑧ To print calibration card.
⑨ To show advanced Setup.
(It is recommended not to set advanced setup.)
⑩ To load or save values.
Get Config.: to get values from current printer

Pic.113 Color density

Pic.114 Resin Black density

Pic.115 Overlay density

57