Pic.81 Running The Netadmin; Pic.82 Network Printer Is Not Found - idp Smart Series User Manual

2.5.2 Network configuration
DHCP (Dynamic Host Configuration Protocol) which automatically assigns IP address to the SMART-50
network printer on the same network is default for IP configuration. If you don't have DHCP server, you
need to set static IP.
Please run NetAdmin.exe in the SMART-50 installation CD to set or change network configuration.
①
②
③
④

Pic.81 Running the NetAdmin

Pic.82 Network printer is not found

NetAdmin is run as the Pic74 after
turning on SMART-50 network printer.
① Printer Connection Status
Searches local network, finds and shows
available network printer.
② Network Module Management
Searches connected encoder on network
module. Reboots, Resets network module.
Firmware upgrade available
③ Printer Configuration
Sets detailed system configuration.
④ Network Information
Shows firmware version of network module
When no printer is connected to
network, there is no printer shown on
the box.
Please click "Refresh". If no printer shown, please
check as below,
1.
Please check the printer is turned on.
2.
Please check network cable is connected to
network hub and works properly (LED lamp
blinking).
3.
Please check if there is DHCP server in the
local network. When DHCP server is not in
your local network, you need to set Static IP.
4.
If Static IP is used, please check the IP
configuration. If another device uses same IP
address, it doesn't work.
38