idp Smart Series User Manual page 15

No LCD Display
Left
S M A R T
12 On
Mag R/W
Spool Error!
13 Blinking
<-Any Key Push->
Print Error xx
14 Blinking
<Replay Cancel>
Top Cover Open
15 Blinking
<-Card Moving ->
Check Please..
16 Blinking
Ribbon Not Found
Check Please..
17 Blinking
Ribbon Zero
Check Please..
18 Blinking
TPH Not Found
Print Error xx
19 Blinking
Top Cover Open
Card Out Error
20 Blinking
<Replay Cancel>
S M A R T
21 On
Download...
Board Test Mode
22
Wait
LED Button
Right Left Right
On
Cancel & Cancel &
Blinking
Initialize Initialize
Cancel &
Blinking Repeat
Initialize
Move a Move a card
Blinking card to the to the front
back side side
Ribbon Ribbon
Blinking
redetecting redetecting
Ribbon Ribbon
Blinking
redetecting redetecting
Blinking
Blinking
Cancel &
Blinking Repeat
Initialize
On
State
Reading or writing the Magnetic encoder is reading or writing the magnetic stripe
Magnetic stripe information.
Printing data is not Shown it when error occurs in a printing data transmission. Press
transmitted properly any keys to delete the spooled data and to return the ready state.
Error in printing or Error in the printing or the transmission. Retry by pressing the left
moving a card button or cancel the command by pressing the right button.
Top cover is open. The card in the printer can be moved by
pressing the left or right LED button. If press both buttons at the
Top cover open
same time, the print head will be up and down. (Flipper will be flip
over if it is installed)
Fail to detect the ribbon. Check the ribbon installed state. If there
There is no ribbon in the
is no ribbon, install the ribbon. If there is a ribbon, pull out it and
printer or fail to detect
install again. Press the left or right button to redetect the ribbon.
It is displayed when the installed ribbon is all used up. Replace
The installed ribbon has
with new ribbon. Press the left or right button to redetect the
run out
ribbon.
Thermal Print Head is not installed or there is a misconnection of
Thermal Print head is not
the cable. Open the top cover to check the print head installed
installed
state or turn off the printer and check the cable connecting state.
Fail to move the card out The card in the printer will be come out when the initialization or
(Check the card in the top cover close. If it is not come out, this message will be
printer) displayed. Remove the card and close the top cover.
Fail to move the card out
After an error occurs in printing, the error card is not come out
(Check the card in the
even though "Replay" or "Cancel" button is pressed.
printer)
The printer is downloading the firmware. Do not turn off the power
Firmware downloading
until it is rebooting. It takes about 20 seconds.
Test mode which can test the sensors or motors of the printer.
Test mode state
User can set the LED status.
Table1 Status display
15
Description