5 Installation
5.3
Connecting the L-509 to the Protective Earth Conductor
INFORMATION
It is only necessary to connect the L-509 to the protective earth conductor when both of the
following conditions are met:
The load on the motion platform of the L-509 must be connected to the protective earth
conductor, but it is not possible to connect the protective earth conductor directly to the
load.
The load and the motion platform are conductively connected with each other.
INFORMATION
Observe the applicable standards for connecting the protective earth conductor.
On the marked longitudinal side of the L-509, there is an M4 hole for the protective earth
conductor connection. In the following figure, this hole is marked with an arrow.
Figure 6: Position of the hole for attaching the protective earth conductor
22
Version: 1.1.0
MP141E
L-509 Stage