5 Installation
5
Installation
In this Chapter
5.1
General Notes on Installation
NOTICE
Unwanted changes in position with vertical mounting!
If the load exceeds the self-locking of the drive when the stage is mounted vertically, unwanted
changes in the position of the motion platform occur. Unwanted changes in the position of the
motion platform can damage the drive, the load or the environment.
When a stage is mounted vertically, make sure that the installed load is lower than the self-
locking of the drive (see specification of the holding force in the data table (p. 47)).
NOTICE
Electrostatic hazard
Touching the pins in the connections of the L-509 can damage electrostatic sensitive devices
(ESD) of the L-509. For this reason, the L-509 is supplied with ESD protection on all
connections.
Do not remove the ESD protection from the connections until you connect the L-509 to the
controller.
NOTICE
Cable break!
A cable break leads to failure of the stage.
Install the stage so that the cable is not bent or crushed too strongly.
L-509 Stage
MP141E
Version: 1.1.0
17