Huawei FusionModule5000 Product Description page 85

FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
Item
DO output
DI input
BLINK
button
Address DIP
switch
E-label
Indicators
Table 3-47 describes the skylight actuator indicators.
Table 3-47 Skylight actuator indicator description
Indicat
or
Power
RUN
ALM
Specifications
One 12 V DC power output for controlling the skylight magnetic lock;
driving six skylight magnetic locks simultaneously
One DI input port for connecting to the window open button
⚫ Hold down the button for less than 1 second to start blinking.
⚫ Hold down the button for 1–5 seconds to search for a network and start
networking.
⚫ Hold down the button for more than 6 seconds to clear network
parameters.
4-pin address DIP switch
Supported
Col
Name
or
Gree Power input
n status indicator
Gree Operating
n status indicator
Red Alarm indicator
Status Description
Steady on The power input is normal.
Off There is no power input.
Off The power is abnormal or the board
program is loading.
Blinking at The skylight actuator successfully
long intervals registers with the ECC800 and the
software runs properly (the
indicator blinks at 0.5 Hz, on for 1s
and then off for 1s).
Blinking at The communication fails or the
short intervals skylight actuator fails to register
with the ECC800 (the indicator
blinks at 4 Hz, on for 0.125s and
then off for 0.125s).
Blinking The indicator blinks at super short
intervals for 0.5s (blinking at 10 Hz,
on for 0.05s and then off for 0.05s)
and then turns off for 0.5s. The
cycle lasts for 10s.
Steady on A system failure alarm is generated.
Off No system alarm is generated.
78