Huawei FusionModule5000 Product Description page 78

FusionModule5000 Smart Modular Data Center
Product Description (ECC800)
Indicator
Wireless Network Pairing (SW) and IP Address Reset (Default) Buttons
Table 3-41 describes the wireless network pairing and IP address reset buttons.
Table 3-41 Wireless network pairing and IP address reset buttons
Button
Name
SW
Colo
Name
r
Red Fault
indicator
Function
Operation Description
Description
Wireless In non-wireless network (802.15.4)
network pairing mode, press and hold down
(802.15.4) the button for 1.2s to 5s to enter the
pairing wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Press and hold down the button for
more than 6s to clear network
parameters.
Status Description
Steady on The converter locks out due to
output overvoltage.
The converter delivers no output
due to internal faults.
Off The converter is working properly.
Indicator Status
The RF_Z indicator
is blinking at super
short intervals.
The RF_Z indicator
is blinking at long
intervals.
The RF_Z indicator
is on.
71