Table of Contents
Advertisement
Using the 7C0x SmartSwitch Hub View
Note that, for all statistical port display form options (both MIB II and Ethernet), three
dashes (---) will display for all inactive ports; any active (green) port will display a
NOTE
numeric value, even if it's zero. In addition, any FDDI or ATM interface will display
three dashes for any Ethernet statistical display selection.
Interface Port Color Codes
The color codes assigned to each port interface in the Interface Application
Display mode indicate a combination of administrative (desired) and operational
(actual) status; note that the color coding is the same for all port display forms:
•
•
•
•
•
Viewing Device Configuration
If you need to call Cabletron's Technical Support about a problem with the Hub
View application or your 7C0x SmartSwitch hardware, you'll need the
information provided in the Device Configuration window. To launch the
window:
1. Click on
2. Drag down to Configuration, and release. The Device Configuration window,
2-20
-
512-1023
-
1024-1518
-
Giants (packets with more than 1518 bytes)
Green — the port is administratively enabled, linked, and operating normally.
Yellow — the port is administratively enabled, but no link is present.
Red — the port is administratively enabled, but not operational; this generally
indicates some kind of malfunction.
Blue — the port is administratively disabled, and is not operational. Note that
this state does not indicate link status.
Magenta — indicates either that a testing mode has been requested but is not
yet in effect, or that testing is taking place.
to display the Device menu; note that this menu is the
same regardless of the Application Display mode currently in effect.
Figure
2-11, will appear.
Monitoring Hub Performance
Advertisement
Table of Contents
