Capability
The Capability display indicates the highest duplex mode of which the interface is
capable. Note that this display does not indicate the current Duplex Mode setting.
•
•
•
Type
The Type display indicates each interface's topology type:
•
•
•
Speed
This display indicates the defined wire speed for each interface's topology. Note
that this speed value does not indicate whether or not a selected port is operating
in Full Duplex mode (which effectively doubles the defined wire speed). Possible
values are:
•
•
Interface Number
Displays the index number assigned to each interface. Index numbers are
assigned in an XXXXYY format, where X = slot index times 10,000, and Y = port
index. For example, an interface index of 30017 would be assigned to port 17 on
the module installed in slot 3 of the chassis.
MIB II Statistics
You can use the MIB II Statistics options to view selected statistics for each port as
a percentage of the total traffic seen on that interface.
•
Monitoring Hub Performance
Full — the interface can be configured to operate in Full Duplex mode.
Fast — the interface is a Fast Ethernet port, and can be configured to operate
in Full Duplex mode. Note that, for a Fast Ethernet port, Full Duplex operation
doubles wire speed from 100 Mbps to 200.
Stand — the interface can operate only in standard mode.
Eth — Ethernet or Fast Ethernet
FDDI
ATM
10M — 10 megabits per second, for standard Ethernet
100M — 100 megabits per second, for Fast Ethernet, FDDI, and ATM
Load — shows a value for each active port that represents that port's traffic as
a percentage of the theoretical maximum load. You can view the load in three
ways:
-
In — indicates the number of inbound packets as percentage of the
theoretical maximum load.
-
Out — indicates the number of outbound packets as a percentage of the
theoretical maximum load.
-
Total — indicates the total number of inbound and outbound packets as a
percentage of the theoretical maximum load.
Using the 7C0x SmartSwitch Hub View
2-17