Table of Contents
Advertisement
The Bridge Application Display
The Bridge Application Display — available only for devices which have been
configured (via Local Management) to operate as traditional bridges — allows
you to view each bridge interface according to bridging status and statistics; it
also provides access to the Bridge and Bridge Port menus
you can launch the Bridge View application, change the port display form, view a
list of source addresses communicating through a selected interface, and enable
or disable a selected interface. This is the default display mode for devices
configured for traditional bridging.
For more information about the Bridge View application, see Chapter 6, Using the
7C0x Bridge View; for more information about viewing source addresses, see
Viewing the Source Address List,
enabling and disabling a bridge interface, see Enabling and Disabling Bridge
Ports,
Bridge Port Display Forms
You can display the following information for each bridging interface:
Admin
Displays the port's current bridging status:
•
Monitoring Hub Performance
Figure 2-9. The Bridge Application Display and Menus
page
2-38. Port display forms are described below.
FWD (forwarding) — the port is on-line and ready to forward packets from
one network segment to another. Note that this is the default display for ports
which are administratively enabled but not connected.
Using the 7C0x SmartSwitch Hub View
page
2-24; and for more information on
(Figure
2-9), from which
2-13
Advertisement
Table of Contents
