Removing The Power Supply Module - Cabletron Systems 7C04 Workgroup SmartSWITCH User Manual

Installation

2.3.4 Removing the Power Supply Module

To remove the power supply module from the chassis, refer to
Figure 2-4 and proceed as follows:
1. Press the power supply's power switch to the off position (O).
2. Unplug the power cord from the power supply and from the
electrical outlet.
3. Locate the knurled knob at the top center of the power supply
module.
4. Loosen the knurled knob by turning it counterclockwise.
5. Grasp the handle located on the front panel of the power
supply and pull the power supply out of the chassis.
2-8
1
WorkGroup SmartSwitch
with SECURE FAST™ VIRTUAL NETWORKING
2
SN
3
4
Figure 2-4. Power Supply Module
FANS
knurled
knob
handle
power
switch