Chapter 2 Installation; Unpacking The 7C04 Chassis - Cabletron Systems 7C04 Workgroup SmartSWITCH User Manual

Cabletron systems user's guide smartswitchtm 7c04 workgroup

Hide thumbs Also See for 7C04 Workgroup SmartSWITCH:

Table of Contents

The 7C04 Chassis can be used as a stand-alone chassis or rack

mounted in a standard 19-inch equipment rack provided there is

sufﬁcient space surrounding the chassis for cooling. This chapter

provides detailed information for unpacking and setting up the

chassis, as well as installing and removing the chassis' power

supply module. You will not need any special tools or equipment;

however, the Site Guidelines detailed in Chapter 1 must be

followed.

Unpack the 7C04 Chassis by using the following steps:

1. Carefully remove the chassis from the shipping box. (Save the

shipping box and packing materials in the event the chassis

must be reshipped.)

2. Slide the two foam end caps off the chassis, and remove the

plastic bag. Set the chassis aside.

3. Remove the accessory package and verify that it contains two

mounting brackets.

4. Examine the chassis (and brackets) and check for damage. If

damage exists, contact Cabletron Systems Technical Support.

CHAPTER 2

INSTALLATION

2-1

Table of Contents