The 7C04 Chassis Power Supply Module; Unpacking The Power Supply Module; Installing The Power Supply Module - Cabletron Systems 7C04 Workgroup SmartSWITCH User Manual

Cabletron systems user's guide smartswitchtm 7c04 workgroup

Hide thumbs Also See for 7C04 Workgroup SmartSWITCH:

Table of Contents

2.3 THE 7C04 CHASSIS POWER SUPPLY MODULE

The 7C04 Chassis is equipped with a removable power supply

module. The power supply module which is located in the right

section of the chassis (Figure 2-2) operates on either 120 volts or

240 volts (AC) and automatically senses input power. The modular

nature of the chassis' power supply allows it to be easily removed

and/or replaced.

Unpack the power supply module by using the following steps:

1. Remove the power supply module from the shipping box.

(Save the shipping box and packing materials in the event the

power supply module must be reshipped.)

2. Slide the two foam end caps off the unit and remove the plastic

bag.

3. Examine the power supply module and check for damage. If

damage exists, DO NOT install the power supply module;

contact Cabletron Systems Technical Support. Otherwise,

install the power supply module (see Section 2.3.2).

To install a power supply module in the 7C04 Chassis, use the

following steps and refer to Figure 2-3.

1. Hold the power supply module by placing one hand on the

handle located on the front panel and using the other hand to

support the body of the module.

2. Make sure you hold the power supply module in the upright

position. A recessed notch running from the front panel to the

back of the module is present only on the top of the module.

Installation

2-5

Table of Contents