Advertisement
3. Tap until the
red
4. Press and hold again for 6 seconds until the LEDs de-illuminate
5. The test will run for a duration of 5 minutes then automatically exit.
EEP Select mode (in progress)
An
Enocean Equipment Profile (EEP)
device it is. The light sensors can support different EEPs, which this test allows you to choose.
1. To enter the main test/config menu, press and hold TEACH/TEST button 6 seconds until the
2. Release button so the
3. Tap until the
red
4. Press and hold again for 6 seconds until the LEDs de-illuminate
5. Release button, the following LED(s) will blink to indicate current selected EEP
a.
Red
and
blue
b.
Blue
LED: FLS-41
c. Patterns will vary by sensor, reference table in sensor's installation guide as needed
guides
at end of article)
6. Tap to select the desired mode/blink pattern from the guide.
7. Press and hold 6 seconds to save the change or wait 60 seconds for the menu to time out (changes will not be
saved that way)
Related Links/References
•
FLS 41 Install Guide
•
MOS Install Guide
•
OWS Install Guide
•
RCS/RVS Install Guide
•
ROS Install Guide
•
TAP 31/41 Install Guide
https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Sensors/Guide_to_Test_and_Co...
LED blinks
is a categorical identifier for a wireless device, essentially saying what type of
green
LED blinks faster
and
blue
LEDs blink together
LEDs: TAP sensors
green
LED blinks
(full list of links to
Updated: Fri, 17 Sep 2021 16:18:01 GMT
Powered by
7
Advertisement
