Installing The Machine; Timing Of The Looper To The Needles; Angle And Height For Installing The Looper - KANSAI SPECIAL V Series Instructions Manual

4 4 4 4 - - - - 2 Installing the machine

2 Installing the machine 2 Installing the machine 2 Installing the machine
Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions.
【5】TIMING OF THE LOOPER TO THE NEEDLES

5 5 5 5 - - - - 1 Angle and height for installing the looper

1 Angle and height for installing the looper 1 Angle and height for installing the looper 1 Angle and height for installing the looper
To obtain the proper angle and height, insert the
looper fully into looper holder A and then tighten
screw B.
The proper angle for the looper on V7100 and W8100
is 3°. Distance at 25mm from the point of the looper
between the bottom of the looper blade and the
extension line from the point of the looper :
Approximately 1.3mm
6