Installing The Machine; Timing Of The Looper To The Needles; Angle And Height For Installing The Looper - KANSAI SPECIAL DVK1702B Instruction

4-2 Installing the machine

Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions.
【5】TIMING OF THE LOOPER TO THE NEEDLES

5-1 Angle and height for installing the looper

To obtain the proper angle and height, insert the
looper fully into looper holder A and then tighten
screw B. The proper angle for the looper on P，
PMD，B，BK is 3°. Distance at 25mm from the
point of the looper between the bottom of the looper
blade and the extension line from the point of the
looper : Approximately 1.3mm.
The proper angle for the looper on MLH is 3.5°.
Distance at 20mm from the point of the looper
between the bottom of the looper blade and the
extension line from the point of the looper:
Approximately 1.2mm. The proper angle for the looper on EHD is 0°.
5