Front And Rear Needle Guards; Position Of The Needle Guard (Rear); Position Of The Needle Guard (Front) - KANSAI SPECIAL V Series Instructions Manual

【6】FRONT AND REAR NEEDLE GUARDS

6 6 6 6 - - - - 1 Position of the needle guard (rear)

1 Position of the needle guard (rear)
1 Position of the needle guard (rear) 1 Position of the needle guard (rear)
■Height adjustment
With needles down at bottom dead center
adjust line a of needle guard A even with the
center of the eye of the right needle.
Adjustment is made by loosening screw D,
raise or lower the guard as needed then
tighten D.
■Clearance adjustment
Clearance between the needles and rear
needle guard should be 0.0mm to 0.05mm.
Adjust by loosening screw B and turning bushing C. Turn C clockwise to move the guard
forward or counterclockwise to move the guard rearward. At this time tighten screw B
slightly.
■On -1S
When the point of the looper has reached the center of
the back side of the right needle, the distance from the
point of the right needle to line A on the needle guard
should be 0.8mm.
0mm clearance between the needle and the needle
guard.
Adjustment is made by loosening screw B.
■ O n W8042 (fixed type)
When the needle bar is at the bottom of its stroke, the
distance from line A to the point of the needle should
be 3mm. Adjustment is made by loosening screw D.
■ O n W8042-1
When the point of the looper has reached the right side
of the needle, the distance from line A to the point of
the needle should be 1mm and the clearance between
the needle and the needle guard should be 0mm.
Adjustment is made by loosening screw E.
adjusting screw F.

6 6 6 6 - - - - 2 Position of the needle guard (front)

2 Position of the needle guard (front)
2 Position of the needle guard (front) 2 Position of the needle guard (front)
When the point of the looper has reached the center of
the right needle, align the center of the right needle's
eye with line A on the needle guard (front).
Adjustment is made by loosening screw B.
The clearance between the needles and the needle
guard (front) should be 0.2~0.5mm.
Adjustment is made by loosening screw C.
At this time, there should be a
9
The height adjustment is made with