Adjusting The Stitch Formation; Position Of The Needle Thread Eyelet; Position Of The Thread Support; Position Of The Spreader Thread Eyelet - KANSAI SPECIAL V Series Instructions Manual

【10】ADJUSTING THE STITCH FORMATION

10- - - - 1 Position of the needle thread eyelet

10 1 Position of the needle thread eyelet
10 10 1 Position of the needle thread eyelet 1 Position of the needle thread eyelet
The distance from the center of the eyelet of the
needle thread eyelet to that of set screw A should be
approximately 16mm (see the illustration).
Adjustment is made by loosening screw A and
moving the thread eyelet up or down.
■To tighten the needle thread, move the thread
guide up.
■To loosen the needle thread, move the thread guide
down.
10

10- - - - 2 Position of the thread support

10 10 2 Position of the thread support 2 Position of the thread support 2 Position of the thread support
With the needle bar at the bottom of its stroke, the
centers of the eyes on thread eyelet A should be
level with the top surface of thread support B and
thread eyelet A should be parallel with thread
support B.
Adjust the height of thread support B by loosening
screw C and moving thread support B up or down.
■To tighten the needle thread, move it up.
■To loosen the needle thread, move it down.

10- - - - 3 Position of the spreader thread eyelet

10 10 10 3 Position of the spreader thread eyelet 3 Position of the spreader thread eyelet 3 Position of the spreader thread eyelet
With the needle bar at the top of its stroke, there
should be a distance of approximately 13mm from
the center of the eye of thread eyelet A to part (a) on
thread eyelet B. Adjustment is made by loosening
screw C and moving thread eyelet A up or down.
13