Stitch Length; Presser Foot Pressure - KANSAI SPECIAL SX Series Instructions Manual

8 8 8 8 - - - - 3 3 3 3 Stitch length

Stitch length Stitch length Stitch length
Adjustable from 2.1mm to 4.2mm with no steps.
The number of stitches per inch (25.4mm) is as follows.
Stitch
length
4.2mm
3.6mm
3.2mm
2.8mm
2.5mm
2.3mm
2.1mm
■To change the stitch length
1. Loosen screw A on the needle guard.
Move needle guard B to the extreme rear end of
the machine.
Then tighten screw A temporarily.
2. Remove rubber plug C.
3. Loosen screw D. To increase the stitch length,
move screw D upward. To decrease the stitch
length, move screw D downward.
4. When the required stitch length is achieved, tighten screw D securely and then
replace rubber plug C.
5. Adjust needle guard B and tighten screw A (refer to "Adjusting the needle guard" on
page 11).
【9】ADJUSTING THE PRESSER FOOT

9 9 9 9 - - - - 1 Presser foot pressure

1 Presser foot pressure 1 Presser foot pressure 1 Presser foot pressure
The presser foot pressure should be as light as
possible, yet be sufficient to produce uniform
stitches and feed the fabric properly.
If the pressure is too light, the fabric may not be fed
evenly or skip stitching and/or uneven stitching may
occur. Adjustment is made by loosening screw A
and turning adjusting screw B.
To increase the pressure, turn adjusting screw B
clockwise. To decrease the pressure, turn adjusting
screw B counterclockwise.
Number of
stitches per inch
6
7
8
9
10
11
12
14