Table of Contents
Advertisement
Installation Requirements
TEST RUN
NAME RATING PLATE
2-4
• Never use a three-to-two wire plug adapter.
• Never use a two-wire extension cord or a two-wire non-grounding
type of multiple-outlet receptacle strip.
To ensure safety, the centrifuge should be wired to a remote emer-
gency switch (preferably outside the room where the centrifuge is
housed, or adjacent to the exit from that room), in order to disconnect
the centrifuge from the main power source in case of a malfunction.
➠
NOTE
During transport between areas with varying
temperatures, condensation may occur inside the
centrifuge. Allow sufficient drying time before
running the centrifuge.
We recommend that you make a test run to ensure that the centrifuge
is in proper operating condition after shipment. See Section 3 for
instructions on operating the centrifuge.
➠
NOTE
After completing the test run, return the
preaddressed warranty card included with this
literature. This will validate the centrifuge
warranty and ensure your receipt of further
information regarding new accessories and/or
modifications as they become available.
When corresponding with Beckman Coulter regarding your
Spinchron DLX centrifuge, always mention its model and serial
number. The serial number is shown on the name rating plate affixed
to the rear of the centrifuge, and is also on the inside of the door.
Advertisement
Table of Contents
