Table of Contents
Advertisement
Action
1. Press [
].
RPM
2. Press ▲ or ▼ until the
selected speed is displayed.
3. Press [
].
ENTER
STOPPING A RUN
Action
1. Press [
].
STOP
(or)
Press [
].
FAST STOP
➠
NOTE
The deceleration rate cannot be changed after
deceleration starts.
Use the parameter keys as described under
, above, to change parameters. You must press [
PARAMETERS
after you input each change. For example, you would change run
speed during centrifugation as follows:
Result
The SPEED display flashes.
The current speed will be displayed, changing to the new value as the
rotor accelerates or decelerates to the new speed selected. The centri-
fuge will automatically calculate the corresponding RCF.
A timed run ends automatically when the TIME display counts down
to zero. To end a run in progress for any reason:
Result
Normal deceleration begins, as selected by the deceleration rate.
Deceleration begins at the maximum rate (see Table 3-1). The decel-
eration process cannot be interrupted; the centrifuge can be restarted
only after the rotor comes to a complete stop and the door is opened
and closed.
ENTERING RUN
ENTER
SPEED
Operation
]
3-9
Advertisement
Table of Contents
