Entering Programming Mode; Exiting Programming Mode - Rosslare AYC-F60 Series Installation And Programming Manual

Controller Operation
You will find instructions for each of the above menu items in the
following subsections.
5.9.1

Entering Programming Mode

•
The unit must be in Normal mode to enter Programming mode.
•
The factory four-digit Programming code is 1234.
•
If a Programming code is not entered within five seconds, the unit
returns to Normal mode.
To enter Programming mode:
1. Press # twice.
The left LED turns off and the right LED turns
red.
2. Enter your 4-digit Programming code.
The left LED turns green.
5.9.2

Exiting Programming Mode

To ex it Programming mode:
1. Press # twice to exit Programming mode at any time.
You hear 3 beeps.
The left LED turns green and the right LED
turns off.
Wrong entries reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for one minute,
the unit exits Programming mode and returns to Normal mode.
AYC-F/G/M60 Series Installation and Programming Manual
Red
Green
Green
39