Lightspeed Active User Manual page 35

FCC Notice to User
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference; and
2. This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna (that is, the antenna for radio or
television that is receiving" the interference).
• •Reorient or relocate and increase the separation between the
telecommunications equipment and receiving antenna.
• •Connect the telecommunications equipment into an outlet on a circuit
different from that to which the receiving antenna is connected.
• •Consult the dealer or an experienced radio/TV technician for help.
ENGLISH:
IMPORTANT NOTE: To comply with the FCC RF exposure compliance
requirements, the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
No change to the antenna or the device is permitted. Any change to the antenna
or the device could result in the device exceeding the RF exposure requirements
and void user's authority to operate the device.
35
FRENCH:
NOTE IMPORTANTE: Pour se conformer au règles d'exposition des ondes RF par la
FCC, la (ou les) antenne(s) utilisée(s) par ce transmetteur doivent être installées de
façon à être séparée d'une distance d'au moins 20 cm de toute personne et ne doit
pas être utilisée près ou en conjonction avec aucune autre antenne ou transmetteur.
Aucune modification à l'antenne ou à l'appareil n'est permise. Toute modification à
l'antenne ou à l'appareil peut résulter que l'appareil excèdera l'exposition aux ondes RF
règlementaires et ainsi annuler le droit à l'usager d'utiliser l'appareil.
FCC RF RADIATION EXPOSURE STATEMENT
For body worn operation, the portable part (Flexmike) has been tested and meets FCC
RF exposure guidelines.
This device must not be co-located or operating in conjunction with any other antenna
or transmitter. The changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTICE TO CANADA USER
ENGLISH
This device complies with Industry Canada licence exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
FRENCH
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes:
1. L'appareil ne doit pas produire de brouillage, et
2. L'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si
le brouillage est susceptible d'en compromettre le fonctionnement