Charging And Pairing Microphones And Pods - Lightspeed Active User Manual

Charging and Pairing Microphones and Pods

CHARGING
All system components should be fully charged (at least 5 hours) for optimum
performance. In most cases, there should be enough battery charge for initial
setup and testing.
• Insert all Pods into the Activate Station. If your system has more than 8 Pods,
the additional Pods can be plugged into the USB charging ports on the back
with the included cables.
• Each Pod will power on and the charge light will turn red to indicate normal
charging. When fully charged, they will turn green.
• Insert the microphone(s) into the left slots of the Activate Station.
• The microphone(s) will power on and the charging light will turn red to
indicate normal charging. When fully charged, it will turn green.
Components are paired and ready for operation when:
Microphone has a solid
white Mic 1 or Mic 2 light
11
Charge Power
Volume Volume
Call
Pod
Power Link
Audio Input Audio Output Tone
Status light is solid white
PAIRING
If your Activate System was purchased together with a Lightspeed audio
system (Redcat, Topcat, 975 or Access Link), all components were paired
together at the factory.
PAIRING ADDITIONAL ACTIVATE SYSTEM COMPONENTS
If the Activate Station and Pods were purchased separately from the
Lightspeed classroom audio system, the new components will need to be
paired with the audio system for operation.
For additional instructions please visit
www.lightspeed-tek.com/accessregistration
Charge Power Charge Power
Volume
Call Call
Pod Pod
Power light is solid blue
LED number is red