Lightspeed Active User Manual page 14

Adjust the Flexmike Volume
1. The Flexmike will automatically power on and mute when it is removed
from the charger.
2. The microphone volume on the Flexmike is set at the factory to the
midpoint. It is adjusted by the up/ down buttons on the side of the mic.
3. While speaking in a normal voice, fine tune the microphone volume.
Proper volume level should be as follows:
• Your voice should be clearly heard by another person on the other side
of the room.
• You should barely be able to hear your own voice.
• There should not be any audio "feedback" or squealing outside of 2-3
feet (if there is, turn the volume down slightly).
REMEMBER: This equipment supplements the user's voice so they are able
to speak in a conversational tone. Having the volume set too high will result in
feedback and listener fatigue.
• Once initial volume level is set, walk around the room and listen for overall
audio quality.
• If further fine tuning is required, you may need to adjust the Tone Control
on the front of the Activate Station.
• If the Flexmike is out of range, it will automatically shut off after 30 minutes
of trying to reconnect. Once you are back in the classroom, or in range,
simply press and hold the power button on the Flexmike to power it up and
resume normal operation.
14
TALK / MUTE LIGHT TALK
MUTE
FLEXMIKE
VOLUME
CONTROL