WATER HEATER APPLICATION
This water heater is designed for the purpose of heating potable water or hydronic heating applications.
Its use in an application other than this may shorten its life.
MODEL TYPE
Congratulations for choosing a Raypak
The operation of the water heater depends on the application. For hot water applications up to 71
W model will be installed. For mechanical heating (hydronic) or for hot water applications above 71
a H model will be installed.
THE WATER HEATER IS FACTORY SUPPLIED FOR USE ON NATURAL GAS. USE ON
PROPANE GAS WILL REQUIRE CONVERSION BY RHEEM SERVICE. CONTACT RHEEM
SERVICE ON 131 031
The model identification number and heater serial number are found on the heater rating plate located
on the upper rear jacket panel of the heater. The model number will have the form 910500BNH or
similar depending on the heater size and configuration. Refer to the table below to determine the model
of heater.
9
1
0
Commercial
Approx Thermal Input
MVB
ABOUT YOUR WATER HEATER
MVB water heater.
®
MODEL IDENTIFICATION
5
0
0
(MJ/h)
Table 1: Model Number Identification
B
Header
Gas Type
Material
N = Nat gas
B = Bronze
P = Propane
C = Cast Iron
10
N
H
Heater
Configuration
H = Hydronic
W = Domestic
Hot Water
o
C, a
o
C,