Table of Contents
Advertisement
TOOLS Menu Tables
1.
TOOLS > System Tools
PAGE 1 – System Tools Screen. Items can only be altered if VERSA control board DIP switch 1 is ON (up)
ITEM
Max Heat
OFF/ON
Monitor
Tap to enter hi/lo recorded temp values screen
Units
Used to change temp units
Defaults
Used to load factory defaults
User Test
Used to perform a user (technician) test
BTC/PIM SW
Versa & PIM Software information
Software RPTS
Software information
Contact Info
Used to enter contact details
Tap to enable performance files to be recorded
Factory
to SD card located on rear top left corner of
Diagnostics
touchscreen
Log File Size
Used to adjust 'Factory Diagnostics' log file size
Whilst in system tools screen (shown above), tap on Monitor button.
PAGE 2 – Monitor Screen. Items can only be adjusted/used if VERSA control board DIP switch 1 is ON (up)
ITEM
Heater Runtime
Heater runtime in hours
DHW Pump
DHW pump P3 runtime in hours
System Pump
System Pump P2 runtime in hours
Inlet Hi / Lo
Highest/Lowest recorded temp for sensor S2
Outlet Hi / Lo
Highest/Lowest recorded temp for sensor S1
Outdoor Hi / Lo
Highest/Lowest recorded temp for sensor S4
Indirect Hi / Lo
Highest/Lowest recorded temp for sensor S5
System Hi / Lo
Highest/Lowest recorded temp for sensor S3
DIP Switches
VERSA control board & PIM DIP switch settings
DISPLAYS
DISPLAYS
95
NOTES
Sets target temp to Target Max para value
whenever any CFH is present. In addition,
DHW priority and WWSD are disabled.
Setting times out after 24 hours or if user set
to OFF
Refer to step 2 below for Monitor screen
Set to °C or °F
Refer to Rheem for resetting all parameter
settings to default factory settings
Refer to Rheem for 'User Test Mode'
-
-
Tap then use keyboard to type contact
details after entering password RAYPAKREP
NOTES
Tap value to reset (clear) value
Tap to view positions: 0 = OFF, 1 = ON
Advertisement
Table of Contents
