Table of Contents
Advertisement
Step 7:
Connect the two RF cables to the antenna connectors on the WLAN module
(Figure 3-16).
Figure 3-16: Connecting RF Cables
Step 8:
Remove the nut and washer from the SMA connector at the other end of the RF
cable.
Step 9:
Insert the SMA connector to the antenna connector holes on the rear panel.
Step 10:
Secure the SMA connector by inserting the washer and tightening it with nut.
Step 11:
Install the external antenna.
Figure 3-17: Securing SMA Connector and External Antenna Installation
Page 24
FLEX-BX100-ULT5
Step 0:
Advertisement
Chapters
Table of Contents
Troubleshooting
