Emptying The Hole Punch Waste Container - Xerox EC70 User Manual

Business Ready Finisher and Booklet Maker
5. To permit the staple cartridge handle to open out and away from the staple refill, press in the
green tabs, then pull back the handle.
6. To remove the staple refill, press the rear of the refill container as shown.
7. Replace the staple refill, then return the staple cartridge to the booklet maker.
E E m m p p t t y y i i n n g g t t h h e e H H o o l l e e P P u u n n c c h h W W a a s s t t e e C C o o n n t t a a i i n n e e r r
When the hole punch waste container is full, a message appears on the control panel.
Note: Do not perform this procedure while the printer is copying or printing.
To empty the hole punch waste container:
1. Open the front door of the Business Ready finisher.
2. Remove the hole punch waste container from its slot near the top left of the finisher.
• Wait 10 seconds before reinserting the container into the printer. The hole punch counter
resets after 10 seconds.
• If you remove the hole punch waste container before the device instructs you to, empty the
container before you reinsert it into the finisher.
172 Xerox ® EC70 Color Copier/Printer
User Guide